Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VIC not supported?

Hi all!

I installed CCM 5.1(2b) and wanted to add an MGCP gateway (I installed it on 2811) with WIC-1B-S/T-V3 to the configuration for the outgoing calls. The problem is that when I configure GW, in "Configured Slots, VICs and Endpoints -> Module in Slot 0 ->NM-4WVIC-MBRD" I dont get WIC-1B-S/T-V3 as an option, only VIC2-2BRI. Does it mean that CCM doesn't support this card or am I doing something wrong?!?

best regards,

Goran

3 REPLIES
Hall of Fame Super Red

Re: VIC not supported?

Hi Goran,

This card is not supported for voice :(. Here is an excerpt from a good doc;

Q. Does the 4-port BRI expansion module support voice and data?

A. The 4-port BRI expansion module supports voice services only. A BRI service provides two 64-kbps B-channels for voice or data and one 16-kbps D-channel for signaling information or data.** BRI data support is available with the Cisco 1-Port BRI S/T WAN card (part number WIC-1B-S/T-V3.

http://www.cisco.com/en/US/products/ps5855/products_qanda_item0900aecd8016c487.shtml

Hope this helps!

Rob

Community Member

Re: VIC not supported?

Thanx very much, helps indeed :)

br,

goran

Hall of Fame Super Red

Re: VIC not supported?

Hi Goran,

You are most welcome :) Sorry for being the bearer of bad news!

Take care,

Rob

129
Views
5
Helpful
3
Replies
CreatePlease to create content