Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VIC2-2BRI-NT/TE configuration for Cisco 2851

Hello,

Do you have a sample configuration for VIC2-2BRI-NT/TE? This device is connected to a Cisco 2851 ISR and used for incoming and outgoing calls.

Thank you,

Ricky

6 REPLIES
Hall of Fame Super Gold

Re: VIC2-2BRI-NT/TE configuration for Cisco 2851

Hi, it depends on various things, which country are you in, do the lines have did? That just to begin with.

New Member

Re: VIC2-2BRI-NT/TE configuration for Cisco 2851

Thanks. I already configured it and it's now working perfectly.

New Member

Re: VIC2-2BRI-NT/TE configuration for Cisco 2851

I spoke to soon. :) I have problems when i unplug the BRI circuits, the link is not turning up.

This is for our Osaka, Japan Office.

Below is my current config:

interface BRI0/0/1

no ip address

isdn switch-type ntt

no isdn spoofing

trunk-group BRI-trunks

Thank you.

Hall of Fame Super Gold

Re: VIC2-2BRI-NT/TE configuration for Cisco 2851

Hi, ISDN BRI by nature doesn't go down when unplugged. How many circuits do you have in trunkgroup ? There is a suggested config to work around that, but if you have one circuit only, isn't needed.

New Member

Re: VIC2-2BRI-NT/TE configuration for Cisco 2851

Thanks for your reply. I have 4 BRI circuits connected to these devices. All of them are member of the trunk group BRI-trunks.

What else am i missing?

Hall of Fame Super Gold

Re: VIC2-2BRI-NT/TE configuration for Cisco 2851

571
Views
0
Helpful
6
Replies
CreatePlease login to create content