Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VIC2-2FXO not being recognized by 2621XM router

I have an FXO card that I have tried to install into 3 different 2621 routers. Each of the routers has an NM-HDV module installed with 4xPVDMs. I believe that the NM-HDVs work fine as I had a VWIC T1 card installed into each of them, and they were all working fine. I tested all three routers by pulling my T1 card out and inserting the FXO card in. In each case, I did a show diag and got the same result. The NM module showed up with no issues as well as the PVDMs. In each case, the FXO shows up under VIC 0 with the following "Unknown WAN daughter card". Of couse, a "show voice-port" command gives me an error as their are no voice ports.

Is the card bad, or am I doing something wrong?

I have checked the Cisco literature and have confirmed that the Cisco 2621XM/NM-HDV/VIC2-2FXO is a supported combination.

1 REPLY

Re: VIC2-2FXO not being recognized by 2621XM router

Hi Jeff,

Make sure you're running an IOS with the voice feature set.

Check this out:

http://www.cisco.com/en/US/products/sw/iosswrel/ps5460/index.html

hth,

nick

228
Views
0
Helpful
1
Replies