Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VIC2-2FXS questions

Hi all,

I want to know what is the frequency used on analog ports of a VIC2-2FXS card. This card is plugged in a 2811 router with a voice software 12.4.

Where can I find this information?

I need to know what is the "cadency of ring's back" too.

Sorry for my bad english I hope you understand me...

3 REPLIES
Hall of Fame Super Gold

Re: VIC2-2FXS questions

Are you talking about ring frequency? Info is in "show voice-port". The settings can be changed with cptone, plus there is further customization you can make.

New Member

Re: VIC2-2FXS questions

I talk about Tone Frequency and cadence. I have to be sure that:

-the tone of dial: 440Hz, continuous.

-the tone of ring: 440Hz, 1,5s yes, 3,5s, repeated

-the tone of congestion: 440Hz, 0,5s yes, 0,5s, repeated.

Can I verify that with "show voice-port" ?

Hall of Fame Super Gold

Re: VIC2-2FXS questions

It doesn't show that. However when you set cptone for a country, tones will be like the ones in that country. Else, you can customize the tones.

See:

http://www.3amsystems.com/wireline/tone-search.htm

to know how are the tones for any country.

106
Views
0
Helpful
3
Replies