Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VIC2-4FXO Port configuration

Hi Guys,

I have pstn lines terminating on a 4port FXO card in Asia and was wondering if anyone had a config i could work with for my voice ports. I am not using DID...thanks...

1 REPLY
Hall of Fame Super Gold

Re: VIC2-4FXO Port configuration

Hi, if you need tone-based disconnect supervision you need the specific for the country, "Asia" is not enough.

Beside that no special configuration is needed, altough a good practice is a THL test to determine optimal impedance:

http://www.cisco.com/en/US/tech/tk652/tk701/technologies_tech_note09186a0080477a06.shtml

But, even without that, will work anyway.

1730
Views
5
Helpful
1
Replies