Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

vic3 2fxs not showing in CCP (no voice folder)

HI Everyone,

For some wacko reason I do not have a voice folder in CCP 2.6.

the 2821 is running 12.4(24)T2, RELEASE SOFTWARE (fc2) and c2800nm-ipvoicek9-mz.124-24.T2.bin

Currently has a vic3-2fxs installed

the 2 voice ports are responsive in cli and give a dial tone with a phone plugged in.

the 2821 has a PVDM2 with 2 DSP's daughtercard.

Any ideas?

Ben.

1 REPLY
Hall of Fame Super Gold

Re: vic3 2fxs not showing in CCP (no voice folder)

You cannot get guaranteed results or sometime not even good ones using CCP.

CCP an other GUIs are only accessories and are not what Cisco bases their products on.

You need to use CLI to properly configure and administer the router.

252
Views
0
Helpful
1
Replies