10-12-2010 01:35 PM - edited 03-16-2019 01:18 AM
I have a CISCO2811 with c2800nm-advipservicesk9-mz.124-21.bin and 1 PVDM2-16.
In one of the HWIC slots I have a VIC3-4FXS/DID= card and the router won't recognized it.
I also have a VIC-4FXS card(older model) and that one works jsut fine.
I am thinking is the IOS version, but not sure.
Any help greatly appreciated.
Thanks
10-12-2010 01:46 PM
You need to update IOS.
10-12-2010 01:51 PM
Mainline won't have support for that card.
Run 12.4(20)T or higher to get support, as per:
http://www.cisco.com/en/US/prod/collateral/routers/ps259/product_data_sheet0900aecd8057f2e0.pdf
I'd recommend going to the latest rebuild of 15.0(1)M if you're going to change code, since that throttle is a mainline throttle and will be sustained for stability through the next couple years. Otherwise, 12.4(24)T4 would be the next best choice.
10-12-2010 02:14 PM
As alternative to 15.0M, my recommendation is 12.4(22)YB6.
The advantage is that it does not requires a memory upgrade.
10-12-2010 03:35 PM
Try 15.1(1)T. I've installed this on a router with 512 DRAM for >6 months and works pretty well. I have PVDM2 and VWIC-1MFT installed.
10-12-2010 03:40 PM
This card should work in any of the 4 HWIC slots correct?
there should be no need to have NM module?
10-12-2010 03:29 PM
Thanks for your responses.
I just installed c2800nm-advipservicesk9-mz.124-25.bin
It won't recognized the VIC3-4FXS/DID=. I have moved it to one of the other 4 slots and same issue.
This IOS version should recognize this card.
10-12-2010 04:09 PM
I loaded the correct IOS as suggested:
c2800nm-advipservicesk9-mz.124-24.T4.bin
This one worked.
Thanks for your help.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: