I have installed 6.0 on vmware in our test lab, but unable to ping new virtual server IP. Install went without any erros and OS boots up fine.
I setup vmware with bridge networking. During 6.0 install, I defined an ip from the same subnet as physical server, same subnet/default gateway. However after install, I am unable to ping virtual server ip. below are ip settings. Any ideas? Maybe driver issues. If so i'm out of luck as 6.0 doesn't let you get to the OS to modify.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...