I have a SIP endpoint connected to a CISCO 2811 (IOS 15.0). The dial peer looks:
dial-peer voice 1 voip
description conection with SIP_endpoint
session protocol sipv2
session target ipv4:192.168.1.60
A test call from g711ulaw works fine. But when I change the codec g711ulaw to a list of codecs something goes wrong. The endpoints return false ringing and put the calls on hold. Also the call go fine if I put only G729br8. The problem apear when add voice class codec. It's a missconfiguration problem or my endpoints has problems with negotiation process?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...