Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

voice gateway bandwidth location

Can an inbound pstn caller to a voice gateway receive a busy signal if the end point ip phone is in a different location and call admission has been instituted across locations?

3 REPLIES
Cisco Employee

Re: voice gateway bandwidth location

You need to tell what you use for call control, is this CME? CUCM? version?

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: voice gateway bandwidth location

CM 6.X location bandwidth control

Cisco Employee

Re: voice gateway bandwidth location

Yes, configure the GW in locationA, the other phones in locationB.

Set the the codec between regions and the calculate how much BW to configure in the locations.

If the call from GW is the N+1 call supported with the BW it will fail and receive reorder, in case it was an ip phone you'll get a message explaining there is no BW.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
268
Views
0
Helpful
3
Replies