I have a brand new CUCM 10.5 environment in my lab. The system (CUCM, CUC, and IM&P) was configured using Prime Colab Provisioning. The phones are provisioned. It (PCP) also built the trunk to my voice gateway.
My voice gateway is a 2921 running Version 15.3(3)M3, and the UC license. It has a T1 card for PSTN connectivity (13 channel PRI). Then for connectivity back to CUCM I was assuming a SIP trunk. I'm looking for configuration guidance on the IOS side. I assume PCP did all the CUCM side. From reading various documents, this is what I have so far. If you could review and let me know if I'm on the right track. Calls aren't working, but I want to verify my config before I start doing debugs.
controller T1 0/0/0 cablelength long 0db ds0-group 1 timeslots 1-13 type e&m-immediate-start
voice service voip fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none sip bind control source-interface GigabitEthernet0/1 bind media source-interface GigabitEthernet0/1 session transport tcp !
voice service voip ip address trusted list ipv4 0.0.0.0 0.0.0.0 mode border-element allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connections sip to sip
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.