Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

voice gateway configuration issue

Hi,

I'm using a CCM 4.1 and a Cisco 2801 (adv ip services) with PVDM-64 and VWIC-2MFT-E1.

When i try to configure pri-group timeslots using the commands : pri-group timeslots 1-31 service mgcp I have the following error message :

%Insufficient resources to create pri-group - it has been removed

Could please see for me what could be the problem ?

P.S : the 2801 router is not a bundle voice, i have just added the PVDM card.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: voice gateway configuration issue

Hi Dominique,

I have seen this in a few instances where the VWIC is installed in slot 0 instead of slot 1. (only WIC modules are supported in slot 0.

Hope this helps!

Rob

5 REPLIES
Hall of Fame Super Red

Re: voice gateway configuration issue

Hi Dominique,

I have seen this in a few instances where the VWIC is installed in slot 0 instead of slot 1. (only WIC modules are supported in slot 0.

Hope this helps!

Rob

New Member

Re: voice gateway configuration issue

Ok, but i think it is not the case for me. See the attached file for the 'sh diag' command response. it indicates that PVDM2-64 is installed on PVDM slot 1.

have a look on this attachment pls.

Cisco Employee

Re: voice gateway configuration issue

Rob never mentioned the PVDM2 module on the wrong slot, but the VWIC in slot 0 when it should be in slot 1.

see what you have:

VIC Slot 0:

E1 (2 port) Multi-Flex Trunk WAN daughter card

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: voice gateway configuration issue

ok ok , excuse me. So I need to replace the VWIC card on slot 1 instead of slot 0.

Let me try it...

Thanks Rob & Javalenc.

Hall of Fame Super Red

Re: voice gateway configuration issue

Hi Dominique,

I think this clip shows the issue;

VIC Slot 0:

E1 (2 port) Multi-Flex Trunk WAN daughter card

Hardware revision 1.0 Board revision D0

Serial number 34010819 Part number 800-04479-03

FRU Part Number VWIC-2MFT-E1=

It does show a VWIC in VIC Slot 0 which is not supported on a 2801. Can you try moving the VWIC-2MFT-E1.

Hope this helps!

Rob

163
Views
5
Helpful
5
Replies