Voice Gateway not allowing outside calls to IP Phones
My current setup is:
2851 Gateway with a 4 fxo card installed
PBX phone line plugged into port 0/0/0
CCM v 5.1
I can call any internal office number and any off site local or long distance number from my IP Phone through the PBX with no problems but when I try to call an IP Phone say DN 3000 I get one ring then a busy signal.
I tried adding the PLAR 3000 command to voice-port 0/0/0 and that did not help.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.