Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Voice Gateway pri-group issue

Hi,

Hope you can help,

have set up an MGCP voice gateway with Callmanager, we have only 12 channels of IDSN PRI in use from the Telco,

Have set up the following on the VG.

pri-group timeslots 1-12,16 service mgcp

all is working great, however, I note that it is defaulting to

pri-group timeslots 1-31 service mgcp.

This is jot a problem when making calls through Callmanager as I have specified `Channel Order Selection` as `Top Down` thereby Channel 1 onwards is used.

This is causing a problem when testing SRST, when debugging I can see the VG tries to use Channel 31 first when an outbound call is made. As I have only channels 1 - 12 available this call fails.

Any ideas?

Thanks

N.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Voice Gateway pri-group issue

The serial interface actually controls the D-channel (signaling channel). You do all configuration that affects processing of the signaling on the D-channel. It is on the D-channel that you can set the B-channel selection order if necessary. You do this by entering interface configuration mode on the D-channel serial interface and using the isdn bchan-number-order {ascending | descending} command

like under interface serial0/0:15

good luck

if helpful Rate

3 REPLIES
Bronze

Re: Voice Gateway pri-group issue

CCM does not have a concept of fractional T1/PRI. If you configure the "ccm-manager config" command on the router it will pull the config from CCM which overwrites the router config. Try manually configuring all MGCP commands in the VG and DO NOT use the ccm-manager config command. This will mean that when you make a change to the gateway in CCM you must manually restart mgcp on the VG in order for the change to take effect.

HTH

Re: Voice Gateway pri-group issue

The serial interface actually controls the D-channel (signaling channel). You do all configuration that affects processing of the signaling on the D-channel. It is on the D-channel that you can set the B-channel selection order if necessary. You do this by entering interface configuration mode on the D-channel serial interface and using the isdn bchan-number-order {ascending | descending} command

like under interface serial0/0:15

good luck

if helpful Rate

New Member

Re: Voice Gateway pri-group issue

Cheers that did the trick!!!

260
Views
9
Helpful
3
Replies