Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

voice gateway PRI

can I use a VWIC2-1MFT-T1/E1 to connect to a Telco PRI? My 3845 is showing a Service-Engine1/0 but not T1 controller.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: voice gateway PRI

Sure you can. Since its a t1/e1 card, it can be configured as a t1 or e1 card. You need to use the card type command from global configuration mode and configure the controller as a t1 or e1. Once this is done, you will see the controller interface show up in running config. Note that if you cofnigure the port as a t1/e1 once, to change from t1 to e1 or vice versa, requires a reboot.

HTH

Sankar

PS: please remember to rate posts!

3 REPLIES

Re: voice gateway PRI

Sure you can. Since its a t1/e1 card, it can be configured as a t1 or e1 card. You need to use the card type command from global configuration mode and configure the controller as a t1 or e1. Once this is done, you will see the controller interface show up in running config. Note that if you cofnigure the port as a t1/e1 once, to change from t1 to e1 or vice versa, requires a reboot.

HTH

Sankar

PS: please remember to rate posts!

Community Member

Re: voice gateway PRI

This might be off subject but do you plan on running mgcp on your router and link it up with your Call Manager?

Community Member

Re: voice gateway PRI

yes

144
Views
5
Helpful
3
Replies
CreatePlease to create content