I need advice on a design. If you have a remote site on a centralised model, and the Wan link is on a seperate router to the Voice gateway. Would you just configure 1 gateway in UCCM(6.1) and point the relevant digits to the voice
gateway and then create a dial peer to point to the relevant outbound wan router?
This would mean the traffic flow would go from phone, to ccm, to vgwy, then back through same vgwy intface and out through wan router. Is there any issue with doing it like this. I am thinking that you would need to go through the Vgwy in case any transcoding is required.
I guess ideally you would want to have the pstn and wan connection on the same router. but in this case it is not possible.
These are the paths to get to each CCX logs through CLI. They may be helpful if you are having issues accessing RTMT or downloading logs through it.
If you want to download them you have to prefix "file get " and you can add one of the options (re...