I had a remote site lose WAN connectivity over the weekend, and SRST kicked in successfully. After the outage was over however, the gateway (2811) did not switch back to the CUCM cluster. show ccm-manager reported all nodes in the cluster as "down" but were pingable, etc. I had to reboot the router to get it to re-register with the cluster.
I can't see any glaring issues with the config on the gateway or within CUCM (7.1.3)...
Well this happened again last night after our WAN provider had a maintenance window. The gateway was up but show ccm-manager show all 3 call managers as down. Rebooting the gateway re-registered it with the primary callmanager.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...