Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
VIP Super Bronze

Voice Interface on serial1/0:15 Status Shows reset

Hi,

I am having a very weird problem on E1-pri card on NM-1CE1T1-PRI module.

After I configured the pri-group timeslots 1-31,16...I noticed the associated voice-port 1/0:15 was not created. Interface serial 1/0:15 was created.

When I do a sh ip int br...The ints1/0:15 status shows reset....

as shown below:

Serial1/0:0 unassigned YES unset reset down

Serial1/0:1 unassigned YES unset reset down

Serial1/0:2 unassigned YES unset reset down

Serial1/0:3 unassigned YES unset reset down

Serial1/0:4 unassigned YES unset reset down

Serial1/0:5 unassigned YES unset reset down

Serial1/0:6 unassigned YES unset reset down

Serial1/0:7 unassigned YES unset reset down

Serial1/0:15 unassigned YES unset reset down

My config looks like this...

card type e1 1

network-clock-participate slot 1

!

isdn switch-type primary-net5

Controller e1 1/0

pri-group timeslots 1-31,16

interface Serial1/0:15

encapsulation hdlc

no ip address

isdn switch-type primary-net5

isdn incoming-voice voice

no cdp enable

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Voice Interface on serial1/0:15 Status Shows reset

NM-1CE1T1-PRI does not support voice.

Hope this helps, please rate post if it does!

3 REPLIES
Hall of Fame Super Gold

Re: Voice Interface on serial1/0:15 Status Shows reset

NM-1CE1T1-PRI does not support voice.

Hope this helps, please rate post if it does!

VIP Super Bronze

Re: Voice Interface on serial1/0:15 Status Shows reset

Thank you!!!!!!!!

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
Hall of Fame Super Gold

Re: Voice Interface on serial1/0:15 Status Shows reset

You're welcome. Thanks for the nice rating and good luck!

656
Views
0
Helpful
3
Replies
CreatePlease to create content