Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Voice Issue between Cisco Call Manager and Nortel PABX

Hi,

We have a Cisco Call Manager (3.3) integrated with a Nortel Meridian PABX. The users from the Cisco Call Manager can call extensions in the Nortel PABX using the access code 2.

The call is established and the Nortel phones ring, but the issue no voice is recieved on both sides.

Im not very experienced with Voice and not sure where to start troubleshooting.

I have collected the debugging for: debug h245 asn1 (attached)

The integration was done through a Voice Gateway (Cisco 3745)

You can also find output for  show isdn status below while the call is estabilshed:

Vsat-Router#sho isdn sta

Vsat-Router#sho isdn status

Global ISDN Switchtype = primary-qsig

ISDN Serial4/0:15 interface

        dsl 0, interface ISDN Switchtype = primary-qsig

         **** Slave side configuration ****

    Layer 1 Status:

        ACTIVE

    Layer 2 Status:

        TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED

    Layer 3 Status:

        1 Active Layer 3 Call(s)

        CCB:callid=8089, sapi=0, ces=0, B-chan=31, calltype=VOICE

    Active dsl 0 CCBs = 1

    The Free Channel Mask:  0xBFFF7FFF

    Number of L2 Discards = 0, L2 Session ID = 10

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Voice Issue between Cisco Call Manager and Nortel PABX

HI,

We have document which shows CUCM and Nortel Meridian using E1 QSIG.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/pbx/interop/notes/431470nt.pdf

Compare your configuration with the document and see if you have missed anything.

Regards

Ronak Patel

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
2 REPLIES
Blue

Voice Issue between Cisco Call Manager and Nortel PABX

HI,

We have document which shows CUCM and Nortel Meridian using E1 QSIG.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/pbx/interop/notes/431470nt.pdf

Compare your configuration with the document and see if you have missed anything.

Regards

Ronak Patel

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
New Member

Voice Issue between Cisco Call Manager and Nortel PABX

Thanks alot Ronak,

I just needed to do some changes in the Voice Gateway

I changed

isdn switch-type primary-qsig

to

isdn switch-type primary-4ess

and under the interface:

I changed

isdn switch-type primary-qsig

to

isdn switch-type primary-net5

Regards

203
Views
0
Helpful
2
Replies
CreatePlease login to create content