On a recent installation (Unity 4.2(1) and CM 4.2(3)) I've started noticing a peculiar issue whereby VM ports on CM stop working properly and need to be reset. There are 96 ports and the failing vm ports seem to happen in succession (in other words, it begins at the first one and goes one on by one until all of the ports run out.) At that point, the ports need to be reset whereby they start acting fine again. Has anyone run into this kind of issue?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...