Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

voice on 2801 with vic3-2fxs/did

hi,

I am trying to configure voice on 2801 with vic3-2fxs/did while IOS is 12.4(20)T

dail tone is available but when i dial number dail tone is still cont...no ring tone

voice-port 0/0/0
input gain 7
cptone BR
timeouts call-disconnect 5
timeouts wait-release 5
!
voice-port 0/0/1
input gain 7
cptone BR
timeouts call-disconnect 5
timeouts wait-release 5
!
dial-peer voice 410 pots
destination-pattern 410
port 0/0/0
!
dial-peer voice 411 pots
destination-pattern 411
port 0/0/1
!

*****

same configuration worked for me using vic2-2fxs with IOS 12.4(15)T or etc.,, now cisco replaced vic2-2fxs with vic3-2fxs/did and it will work only on IOS 12.4(15)ZX or 12.4(20)T. after upgrading IOS router can  see the voice card and i configured ports ..dail tone there but when dailing on number dail tone is not changing to ring tone..

pls advise.. Thanks

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: voice on 2801 with vic3-2fxs/did

That should be all you need to get this to work.  Collect:

debug voip ccapi inout

debug vpm sig

And for kicks, try it with input gain at 0.

2 REPLIES
Cisco Employee

Re: voice on 2801 with vic3-2fxs/did

That should be all you need to get this to work.  Collect:

debug voip ccapi inout

debug vpm sig

And for kicks, try it with input gain at 0.

New Member

Re: voice on 2801 with vic3-2fxs/did

Hi Steven,

Thanks for your support man..Input gain 0 worked.. thanks again.

regards,

671
Views
0
Helpful
2
Replies
CreatePlease login to create content