Anyone use IP over powerlines for a voice install yet. I have a customer where they use these on a hosted SIP with Cisco phones and seem to be alright. Phones plug into Powerline modem, CPU into phone to a 2950. They want to move off of hosted to a local CME and I don't understand if I will have any QoS issues being they go through the powerline modem or if that is just a layer 1 type of device. Any help understanding this a bit better would be appreciated.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.