1. I have IP communicator on the 10.20.50.0 network that i want to register with a VPN tunnel. I create a tunnel to the ASA5505 and when i try to ping the
10.20.100.0 network, there is no problem, but when i try to reach the other two - 10.10.100.0 and 192.168.100.0 i can't. There is a trunk between the 3945 and the netgear switch. Do you have any ideas what should i do to connect to the 10.10.100.0 network? Thanks
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...