this problem arose today and I am stumped. Our voice paging system is giving off a busy signal. i would go around check the phones to see if one is perhaps "off the hook" but there are about 350 on this site and i dont have the time. PLEASE HELP!
I'm not sure how your Paging system is connected, but I'm guessing via FXS or ATA (maybe VG port). In any case, I would think that you could do a reset of the specified port and it would clear the call. Failing that you could just disconnect the line to the Paging system as well.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...