Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

voice port configuration

Below is the partial configuration.

My Query is when 3/0/0 and 3/0/1 ports are busy with local calls (calls starting with non zero numbers), then the local calls should be established on 2/1/x which are configured for calls starting with '0'. This configuration is not working, needs modification. Pls help in this

dial-peer voice 210 pots

preference 8

destination-pattern 0[1-4,6-9][0-9]?

no digit-strip

direct-inward-dial

port 2/1/0

!

dial-peer voice 211 pots

preference 8

destination-pattern 00[1-4,6-9][0-9]?

no digit-strip

port 2/1/1

!

dial-peer voice 300 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/0

!

dial-peer voice 301 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/1

dial-peer voice 210 pots

preference 8

destination-pattern 0[1-4,6-9][0-9]?

no digit-strip

direct-inward-dial

port 2/1/0

!

dial-peer voice 211 pots

preference 8

destination-pattern 00[1-4,6-9][0-9]?

no digit-strip

port 2/1/1

!

dial-peer voice 300 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/0

!

dial-peer voice 301 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/1

dial-peer voice 210 pots

preference 8

destination-pattern 0[1-4,6-9][0-9]?

no digit-strip

direct-inward-dial

port 2/1/0

!

dial-peer voice 211 pots

preference 8

destination-pattern 00[1-4,6-9][0-9]?

no digit-strip

port 2/1/1

!

dial-peer voice 300 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/0

!

dial-peer voice 301 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/1

2 REPLIES
New Member

Re: voice port configuration

Play with preference command, if you give low preference value the call will routed via that port, higher the preference value at port for back-up route.

Hall of Fame Super Gold

Re: voice port configuration

You should use trunkgroups (configure under voice-port and in place of port unde DP). That way you will:

- have single DP eliminating redundant configuration

- be able to use multiple trunk-group for a same DP, if desired.

- define precedence for individual lines with trunk-group

- define an hunt-scheme on how to use the lines

- pull statistics on trunkgroup usage and it's individual lines.

Hope this helps, please rate post if it does!

204
Views
0
Helpful
2
Replies
CreatePlease login to create content