Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Voice Ports on Router and VG224

I Hvae a 2811 Router with 4 FXO and 4 FXS ports and 16 Port Switch, also a VG224 now i have analog phones connected to VG224 and Voip phones connected to Switch and they can call each other no problem the problem i am haveing is using FXO or FXS ports to connect to what we believe is PBX system and not sure how to program the routers dial peers and  voice ports so that all analog phones on vg224 and Voip on router can Dial out through PBX and also the line that is used has a specific extention like 2312 so if outside world called that number direct it to specific phone

Everyone's tags (4)
1 REPLY
Cisco Employee

There's nothing particular to

There's nothing particular to what you're trying to do, just configure the POTS dial peer with the destination pattern you want, and tie it to the port you want the call to go out.

For inbound calls, configure the connection plar to the DN you wish to ring.

voice-port 0/0/2

 connection plar opx 4000

 

dial-peer voice 24 pots

 destination-pattern 91[2-9]..[2-9]......

 forward-digits 11

 port 0/0/2

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
99
Views
0
Helpful
1
Replies