Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Voice PRI-GROUP Test??

Hello All,

I have 2x 2621 routers that are configured back to back using a T1 crossover cable (VWICS). I just need to know if my config is right and how do I test the channels to see if they go active for a going call. The config it below. Thanks.

Router 1




controller T1 1/0


  linecode b8zs


  framing esf


  clock source line


  (User Side)


  pri-group timeslot 1-12



int s1/0:23


                isdn incoming-voice voice


        isdn protocol-emulate user




Router 2




controller T1 1/0


  linecode b8zs


  framing esf


  clock source internal


  (Switching Side)


  pri-group timeslot 1-12


int s1/0:23


                isdn incoming-voice voice


        isdn protocol-emulate network

3 REPLIES

Re: Voice PRI-GROUP Test??

Hi,

You can use SJphone with direct H.323 option or can configure IOS based CallManager Express and register Cisco IP communicator as many as you want.

Regards,

Muhammad Amir Raza

Re: Voice PRI-GROUP Test??

To see if channels are going active for a call use debug isdn q931.  Even if you're doing a back-to-back configuration between routers you should still see the call setup and teardown.

Re: Voice PRI-GROUP Test??

Cool Loreena, I'm glad I could help!

Don't forget to mark your issue as "resolved" and rate any helpful posts

307
Views
3
Helpful
3
Replies
CreatePlease to create content