Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Voice translation-rule do't want to work

diagram:

Phone1(100) - FXS2/0/1 - Cisco 2851 - FXS2/0/2 - Phone2(200)

I do't want that phone1 make calls to phone2:

voice translation-rule 1

rule 1 reject /200/

voice translation-profile block

translate called 1

dial-peer voice 1 pots

call-block translation-profile incoming block

call-block disconnect-cause incoming call-reject

service mgcpapp

port 2/0/1

Check config:

#test voice translation-rule 1 200

200 blocked on rule 1

But phone1 still can make calls to phone2, what i'm doing wrong?

  • IP Telephony
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Voice translation-rule do't want to work

Hi,

I don't think you can use translation rules with mgcp-controlled ports.

1 REPLY
Hall of Fame Super Gold

Re: Voice translation-rule do't want to work

Hi,

I don't think you can use translation rules with mgcp-controlled ports.

134
Views
0
Helpful
1
Replies