Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Voicegateway FXO to cucm extension

Hi,

we have 2921 router connected with 4 pstn line. and router added to the cucm 8.5 using h.323 

how can i map one  pstn number 3424758xx to extension 2500 ?

i have mapped as below but when dial from outside to 3424758xx just ring no indication on 2500. 

Foreign Exchange Office 0/1/0 Slot is 0, Sub-unit is 1, Port is 0
 Type of VoicePort is FXO
 Operation State is DORMANT
 Administrative State is UP
 No Interface Down Failure
 Description is not set
 Noise Regeneration is enabled
 Non Linear Processing is enabled

 

voice-port 0/1/0
 signal groundStart
 connection plar opx 2500

 

dial-peer voice 1 voip
 description VoIP Trunk to Cucm
 destination-pattern [1-9]...
 session target ipv4:172.25.25.16
 incoming called-number .
 voice-class codec 1
 voice-class h323 1
 dtmf-relay h245-alphanumeric
 no vad

dial-peer voice 3 pots
 incoming called-number .
 direct-inward-dial
!
dial-peer voice 4 pots
 incoming called-number .
 port 0/1/0

 

 

 

 

 

 

 

 

 

 

 

Thanks,

 

2 REPLIES

Hi Frank, 1.) Is the number

Hi Frank,

 

1.) Is the number 2500 assigned to a phone/hunt-pilot?

2.) Do a debug voip dialpeer inout

New Member

Hi Zekeria,2500 assigned to

Hi Zekeria,

2500 assigned to the phone.

no output for above debug command

Thanks

67
Views
0
Helpful
2
Replies