Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VoiceT1 CAS - Loop start

Hi,

I have a Voice T1 circuit running loop start signalling. I do not know how to configure the Controller T1 interface on my 3825 router.

Has someone does this, please help me with the commands.

I tried

controller t1 0/1/0

dso-group 1 timeslots 1-24 type dfd

framing SF

linecode B8ZS

Thanks in advance,

Joel

6 REPLIES
Green
Green

Re: VoiceT1 CAS - Loop start

New Member

Re: VoiceT1 CAS - Loop start

Hey, thanks for the links the last one was very informative.

It only tells me that I can use either

ds0-group 1 timeslots 1-24 type e&m-fgb (OR)

ds0-group 0 timeslots 1-24 type e&m-fgb dtmf dnis

or other types, but I do not know what I need to use for LOOP START.

Is there a particular ds0-group TYPE that I need to use???

Thanks,

Joel

Hall of Fame Super Gold

Re: VoiceT1 CAS - Loop start

Hello,

Is the T1 line from a telco switch, and the router "pretends" to be 24 telephones ?

If so, type should be fxo-loop-start.

New Member

Re: VoiceT1 CAS - Loop start

I don't know, would you be able to tell based on this:

The T1 line comes in from the telco to a SmartJack (trunk card) and then goes to a Adtran 850. I am connecting to the Adtran's DSX0 port.

My controller T1 comes up, but voice does not come in.

Thanks,

Joel

Hall of Fame Super Gold

Re: VoiceT1 CAS - Loop start

Hi,

If telco has given to these lines one or more numbers that you can call from any telephone, then yes these are fxo-loop-start.

Note this is a type of singaling that can give you problems because of lack on disconnect supervision (among other things), so if you want things to run really smooth and easy, ask telco if they can make the circuit to be ISDN PRI instead.

Hope this helps, please rate post if it does!

162
Views
2
Helpful
6
Replies