Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

voip configuration problems

Hi,


I am trying to configure voip lab where I have two voice router with fxo and fxs interfaces, I have analog line connected to fxo but I need to dial 89 to get external calls, I configured dial-peers pots and voips, if I dial an external line from fxs interface in the same router I can get a dial tone and dial my outside pstn number, but from the other router I cannot call pstn through the other router pstn connection, their is no dial tone when calling 89.


I have on the other router a dial-peer voip connection with destination pattern 89 which points to the ip address of the other router, and on the first router connected to the pstn I have a pots dial-peer pointing to fxo interface.

what is the problem

5 REPLIES

Re: voip configuration problems

hi

you have somting like

phone---router2-----router1--pstn

router2:

dial-peer vocie 1 voip

destination-pattren 89

seesion target [router1 ip]

router1:

dial-peer voice 2 pots

destination-pattren 89

port [fxo prt number]

you should get a dial  ton one you dial 89 then you can dial PSTN numbers

good luck

if helpful Rate

New Member

Re: voip configuration problems

Hi,

Thanks for reply,

yes this exactly my configuration but when dialing 89 from the other side using voip dial-peer 89 I cannot get a dial tone.

Re: voip configuration problems

Hi,

Dial tone is provided from the FXS voice port. If you don't receive dial tone it could be related to configuration issues, faulty network module or FXS cards, cables, DSP issues or IOS bugs.

You can try changing the FXS cards and check if you can get dial tone.

Hope it helps, if it does please rate.

Best regards,

-- Adrián.

New Member

Re: voip configuration problems

I can get a dial tone when going offhook but when dialing 89 I should get a dial tone from the fxo port in the other router to dial to pstn.

New Member

Re: voip configuration problems

I solved the porblem it was because if protocol mismatch in the two routers, I was using sip in the first router in dialpeer and h323 in the other, I changed the dialpeer in the second router to sip.

318
Views
0
Helpful
5
Replies