Currently in our organization we have VoIP running only in our headoffice. That is from the HO we can call the other office through the use of dialing an extension. I'm not sure how this is setup as it was done some time back by others. What I want to do is, to be able to expan VoIP to the remote branches. I have been doing some reading in Cisco on Cisco Unified Communications Manager, but it's just taking me from page to page. What are the basics of setting up a VoIP environment in a network? Please give me some ideas what steps to take and and to identify what's needed for a VoIP environment.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...