Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
Community Member

VoIP Lab-Router Setup

Can you run SDM and CME 3.0 both on a Cisco 3640 with internal 64M flash and 128M RAM, plus 20meg external flash card? Plus any configuration documentation would be helpful?

Thanks in Advance.



Re: VoIP Lab-Router Setup

Cisco Unified Communications Express is an award-winning IP communications solution that is provided with the Cisco Integrated Services Router portfolio. Cisco Unified Communications Express includes:

"Cisco Unified CallManager Express to provide rich call processing

"Cisco Unity Express to provides integrated messaging with an AIM or NM module

"Full portfolio of IP phones to meet the small medium business needs

"Full-featured voice over IP (VoIP) capability to support H.323 and Session Initiation Protocol (SIP) implementations

"Voice gateways supporting VG224 and analog telephone adaptors (ATA)

Hall of Fame Super Gold

Re: VoIP Lab-Router Setup

Please stop posting pasted text that is irrelevant to the question asked.

Cisco Employee

Re: VoIP Lab-Router Setup

Completely agree about irrelevant posts!

Cisco SDM is a web-based configuration tool that allows you to configure LAN and WAN interfaces, routing, Network Admission Control (NAC), Network Address Translation (NAT), firewalls, Intrusion Prevention System (IPS), Virtual Private Networks (VPNs), and other features on the router.

SDM will run on the 3640. Refer here for release notes -

For the 3640 router, you will need -

12.2(11)T6 or later releases

12.3(2)T or later releases

12.3(1)M or later releases



12.4(2)T or later releases

64 meg flash and 128 meg DRAM should be fine !

Some config guides are here -

SDM does not do any voice configurations. Since you are talking about CME 3.0 (or later) then you can use the CME GUI and CLI to configure the voice features. Refer here for configuration details -

CreatePlease to create content