I have a bunch of L2L VPN's that I'd like to configure QoS for VoIP on. I have started down this path with the following configuration:
match dscp ef class-map Data match flow ip destination-address match tunnel-group DefaultL2LGroup ! My L2L tunnel to another site
policy-map VoicePolicy class-Voice priority class Data shape average [75% of upload bandwidth converted to bps] service-policy VoicePolicy interface outside priority-queue outside
When trying to put in the shaping command, i get this error:
(config-pmap-c)# shape average 1179648
ERROR: Shape not allowed with legacy priority in the same policy-map
Should I not give my Voice class priority? Is there a better way of doing this? I was trying to limit the amount of bandwidth that data uses so that the Voice traffic always had 25% of the upload bandwidth available. Please help!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.