I bought a Cisco E1200 router to use with a strong vpn. I flashed it successfully following thier instructions. I works fine as a pass-through for my internet connection and as a wireless source. But when I connect to the Strong Vpn through their client, I get a blue screen on my Windows 7 after about 5-10 minutes. The bluescreen says it is related to the new hardware. The only new hardware is the router. Any thoughts on how to resolve this issue? Thanks!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...