Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VWIC2 ? voice and data on same card?

I am planning to install a 3825 router that will be a data WAN router and a voice gateway. It will have a data T1 and a voice PRI. Can the same VWIC2-2MFT-T1/E1 card serve both circuits? Or once I configure 'voice-card 0' will that card be only usable for voice?

2 REPLIES

Re: VWIC2 ? voice and data on same card?

The VWIC2-2MFT-T1/E1 has a single PLL, meaning it can only clock from one of the two ports. This may or may not be a problem depending on carrier, and if you can supply clock to them as a workaround. If in doubt don't do it. Clocking issues on voice causes faxes/modems to fail, and on data causes re-transmits.

New Member

Re: VWIC2 ? voice and data on same card?

I came across the same problem recently and was told by my parnter that a VWIC card can only use once clock source, and that if you are using the same carrier for the data T1 and PRI you should be OK.

I had the luxury of having 2 VWICs in the router, so I put voice in one and data in the other; and I have room for growth.

144
Views
0
Helpful
2
Replies