09-12-2008 11:58 PM - edited 03-15-2019 01:15 PM
Can anyone tell me how I can control the number of calls going across a wan link. I am aware you can use locations in CCM. This scenario however is different. 1 site is ccm and the other is a PBX. They are connected via 2 routers using QSIG. I was hoping there was something you can do on the routers
Solved! Go to Solution.
09-13-2008 12:43 AM
simply on the outgoing dial peer add the foolowing cammnad
dial-peer voice 9 voip
max-conn [max number of calls]
for wxample if u want to limit the number of calls to 9
do the following on the outbound voip dialpeer going to the other one
dial-peer voice 1 voip
max-conn 9
! 9 calls allowed on VoIP Dial Peer to Remote Site
good luck
if helpful Rate
09-13-2008 12:43 AM
simply on the outgoing dial peer add the foolowing cammnad
dial-peer voice 9 voip
max-conn [max number of calls]
for wxample if u want to limit the number of calls to 9
do the following on the outbound voip dialpeer going to the other one
dial-peer voice 1 voip
max-conn 9
! 9 calls allowed on VoIP Dial Peer to Remote Site
good luck
if helpful Rate
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide