Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

wan link call control

Can anyone tell me how I can control the number of calls going across a wan link. I am aware you can use locations in CCM. This scenario however is different. 1 site is ccm and the other is a PBX. They are connected via 2 routers using QSIG. I was hoping there was something you can do on the routers

1 ACCEPTED SOLUTION

Accepted Solutions

Re: wan link call control

simply on the outgoing dial peer add the foolowing cammnad

dial-peer voice 9 voip

max-conn [max number of calls]

for wxample if u want to limit the number of calls to 9

do the following on the outbound voip dialpeer going to the other one

dial-peer voice 1 voip

max-conn 9

! 9 calls allowed on VoIP Dial Peer to Remote Site

good luck

if helpful Rate

1 REPLY

Re: wan link call control

simply on the outgoing dial peer add the foolowing cammnad

dial-peer voice 9 voip

max-conn [max number of calls]

for wxample if u want to limit the number of calls to 9

do the following on the outbound voip dialpeer going to the other one

dial-peer voice 1 voip

max-conn 9

! 9 calls allowed on VoIP Dial Peer to Remote Site

good luck

if helpful Rate

125
Views
0
Helpful
1
Replies