We are using private addresses for our IP Phones. We cannot connect via web access to the phones that are using private IP addresses. We under LAN Settings on the computer we have checked bypass proxy for local sites, and we have made sure that the phone is set for web access in the call manager admin. Web Access to phones using public space works without problems. What else do we need to do?
Have you verified that you can ping the devices you are trying to view the web page on? And if you can ping it, is their some type of firewall in place between your end and the phone end maybe blocking http?
Yes I make phone calls to that phone no problem, my management just wants me to get web access working. There shouldn't be a firewall in between me and the phone considering the two devices are on the same VTP domain, just different VLANS. The firewalls that have deployed are at a much higher level.
since you are on 2 different vlans (voice/data) call to call would be on different subnets than if you were to ping the device. From your pc, verify you can ping the device. Verify you dont have any ACL or Vlan maps applied at the switch level.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.