We are trying to integrate E&M ( VIC3-2E/M) card with voice Gateway& CUCM scenario, we are unable to get proper documents in order to accomplish this task, if any one experiences earlier, please help us. Following is the scnario
1. CUCM 8.6 version , VG : cisco 2921 -- Pstn with PRI terminated
we would like to register E&M interface just like any other FXS/FXO with CUCM, is posible
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...