Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

What's the latest firmware for LinkSys SPA8000 ATA ?

We have 6 SPA8000 ATA LinkSys boxes and are having a variety of issues (below) trying to deploy them -- what/where is the latest version of the firmware for these boxes?

The current version (5.1.10) as these issues (incomplete list and in no particular order):

* one unit changed its LAN address from 192.168.0.1 to 198.168.1.1 even though this is apparently unchangeable... at least, a reset from an analog port worked.

* setting VLAN to 0x10 is not the same as 16 (even the on-screen info reads "[0x000-0xFFF]" -- go figure)

* settings can't be reliably unset -- clearing settings (extension, password, name) does nothing -- extension stays registered until the PBX/Proxy address is cleared.

* re-using a SPA8000 which was used as a test unit to a test Switchvox; changing an extension's parameters "looks" OK on the web interface -- BUT, the extension, while pointed to the production Switchvox according to the display, is still pointing to the test system.  Changing the Proxy(PBX) address has no effect -- no matter what I set it to, Switchvox diagnostics gets this wrong IP from the SPA8000:

SPD_E_INVALID_TYPE~~ 10.35.3.2     Using a numeric IP address instead of a canonical one, the extension finally registers.

1234
Views
0
Helpful
0
Replies