Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Highlighted
Community Member

What will happen when phone reset in SRST mode?

Hi All,

 

What will happen when phone reset in SRST mode? 

Suppose the phone lost the connectivity to the DC, where all the servers placed[Including primary,secondary and TFTP] And the phones fallback to SRST mode.

And being in srst mode

What will happen if phone restart?

What will happen if phone reset?

Will they fall back to SRST again

 

 

 

1 ACCEPTED SOLUTION

Accepted Solutions

Re: What will happen when phone reset in SRST mode?

If the phone is rebooted due to power outage it will normally register back to SRST. If you factory reset settings it will not, as it will need contact the primary CUCM to get the configuration.

Georgios
Please rate if you find this helpful.
2 REPLIES

Re: What will happen when phone reset in SRST mode?

If the phone is rebooted due to power outage it will normally register back to SRST. If you factory reset settings it will not, as it will need contact the primary CUCM to get the configuration.

Georgios
Please rate if you find this helpful.
Cisco Employee

Re: What will happen when phone reset in SRST mode?

You are not supposed to do that while the devices are in SRST. It is not supported/recommended.
With IP Phones if might be fine since they cache the config file and won't request for it again. With devices like an ATA, if the device is reset while in SRST, it won't register back since the TFTP services will be down as well.
Something to remember just in case.

Nipun Singh Raghav
"We cannot solve our problems with the same thinking we used when we created them"
146
Views
0
Helpful
2
Replies