Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Where in 6509 config do I put qos statements?

I have a port channel configured and two Sup32 SFP gig ports in the channel. This etherchannel is the uplink from this 6509 to another 6509 and I need to apply the appropriate wrr-queue qos statements.

Do these statements go on each individual SFP gig interface, or just on the port channel interface?

Here are the appropriate interface configs:

interface Port-channel1

ip address 164.7x.xx.xx 255.255.255.252

ip pim sparse-mode

interface GigabitEthernet5/1

no ip address

channel-group 1 mode desirable

!

interface GigabitEthernet5/2

no ip address

channel-group 1 mode desirable

I think the queue commands go on the hardware interfaces but I just want to make sure.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Where in 6509 config do I put qos statements?

You can put that on the hardware interfaces.

1 REPLY

Re: Where in 6509 config do I put qos statements?

You can put that on the hardware interfaces.

110
Views
0
Helpful
1
Replies
CreatePlease to create content