Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Which mode of fax service is more reliable?

I am actually using Fax Pass-through and I am having few problems.

Is fax mode a better solution?

Also, what should be the input and output level of the FXS port?

I am on the same VLAN, network is good and my GW is in MGCP and ATA is in SCCP.

Super G3 fax is disable and ECM is off. Soemtimes I can see retries on the fax.

Thanks

3 REPLIES
Bronze

Re: Which mode of fax service is more reliable?

Hi,

ATA is only good for passthrough, and this is the most unrecommended way ...

Can you put the fax on a local FXS port in the same gateway? Do you have alternatives?

If not then try to limit the fax to 9600bps.

HTH, Avner.

New Member

Re: Which mode of fax service is more reliable?

Hello,

Thanks for the reply. I only have an ATA for the fax.

Is the VG224 a better choice?

Is the FXS card doing super G3 faxes?

Thanks

Bronze

Re: Which mode of fax service is more reliable?

Hi,

VG224 is a better option. it supports fax relay as well as passthrough.

Using an FXS card in the router that terminates the PRI should allow super G3 since there is no conversion to IP and back.

HTH, Avner.

141
Views
5
Helpful
3
Replies
CreatePlease to create content