Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Wiered issue on dial-peer

I have two dial-peers

1.

dial-peer voice 513 pots

trunkgroup LOCAL-PSTN

translation-profile outgoing drop_one

preference 1

destination 9513.......

progress_ind alert enable 8

forward-digits 7

2. dial-peer voie 1999 pots

trunkgroup LD-PSTN

translation-profile outgoing drop_one

preference 1

destination-pattern .T

progres_ind alert enable 8

incoming called-number .

direct-inward-dial

forward-digits 10

prefix1

A  a made a call to 9XXX-XXXX

It matches the 9.XXXXXXX in the route pattern

We are doing a predot discard and prefixing 9513 which becomes 9513XXXXXXX in Route list

Gateway gets the number 9513XXXXXXX where we have a dialpeer for it which is dial-peer 513.

But for only two calls(as of I know) it didn't hit dial-peer 513 but it hit dial-peer 1999.

It hit dial-peer 1999 and the call went as 1951-3XX-XXXX

What could be the possible scenario to hit the dial-peer 1999 instead of 513.???

1 REPLY
Hall of Fame Super Silver

Wiered issue on dial-peer

Perhaps all ports assigned to LOCAL-PTSN trunk groups were busy.

Do you by any chance have a "debug voice dialpeer" for that call? This would reveal what happened.

Chris

129
Views
0
Helpful
1
Replies
CreatePlease to create content