We have a customer who is installing CCM 5.x and would like to integrate it with his Windows LDAP directory, my question is what do we use in the BAT file for each user? Is there a document with all the fields?
We have just completed a ccm 5.1 install with LDAP integration. We used BAT to import phones and LDAP to import users from AD. We then used BAT to update users to associate the corresponding user to device. However after trial an error and some odd isssues with BAT the method we used ( as it worked )was as follows : 1) add phones using bat. 2)Create LDAP directory to import users.
3) once users imported delete LDAP directory . (If we tried updating users when the syncronisation was still enabled the bat file ran but when you went to the user the device was not there)
4) use BAT to update users and associate devices to relevant users.( when this step was done it associated the devices with the users but changed all users surnames to **SURNAME** )
5) Re-create the LDAP Directory and perform a full sync and this corrects the surnames to what they need to be.
6) Hey presto you re done.
This is how we managed to get it working, There may be other methods out there. Good Luck
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...