I have setup one CUCM and one UnityConnection. And I setup serveral IPcommunicator phone. Integration btw CUCM and UnityCN seems good, since voice mail can work. But when I dial WMI on DN, the IPC say "your call canot be completed at dialed, pls consult your directory and call again".
The CSS of WMI DN is the highest and it's Partition is lowest, so I think the IPC have the right to dial WMI
Is is right on IPC(version 7.0). And I found there are signs "you have voicemail" on the bottom of the screen, but when I press the voicemail button, it say I didn't have new mail.
I have configure portgroup on unitycn and voicemail on CUCM, and associate voicemail profile on the specific DN of IPC, is it right that I cannot dial the WMI on and WMI off DN? Or are there some configuration missed?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...