Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

WS-SVC-CMM connectivity problem

Hi to all,

I have a WS-SVC-CMM in a catalyst A and I have a connectivity problem, I have some Ip phones in catalyst C but if I ping from the WS-SVC-CMM there is no ping but from the catalyst Aºwhere the WS-SVC-CMM is installed I ping them and if ping from the card to this catalys is ok, I supposed I need some command to ping from WS-SVC-CMM.

Best regards,

Alberto

1 REPLY
Bronze

Re: WS-SVC-CMM connectivity problem

Configure the CMM in bus mode.

Issue the fabric switching-mode force bus-mode config command. This command forces the fabric connection of the service module to bus mode.

111
Views
0
Helpful
1
Replies
CreatePlease to create content