Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

XConference transcoding problem..

Hi Experts

I have a 2800 Software (C2800NM-ADVIPSERVICESK9-M) on location A, and 2801 Software (C2801-ADVIPSERVICESK9-M) location B. Voip is going trough wan to site b, I am trying to configure xconference but its not working (conferece cannot be completed).

Here is the config:

dial-peer voice 100 voip

destination-pattern 4...

session target ipv4:20x.106.2x6.178

session transport tcp

voice class codec 1

dtmf-relay rtp-nte

no vad

voice class codec 1

codec preference 1 g729r8

sccp ccm group 1

associate profile 1 register Transcode1

associate profile 2 register conference1

dspfarm profile 2 conference

codec g729r8

maximum sessions 2

associate application SCCP

no sh

sccp local FastEthernet0/0

sccp ccm 192.168.0.200 priority 1

sccp

On location B I have:

dial-peer voice 100 voip

destination-pattern 6...

no session protocol sipv2

voice-class codec 1

session target ipv4:20x.19x.135.146

session transport tcp

dtmf-relay rtp-nte

no vad

voice class codec 1

codec preference 1 g729r8

codec preference 2 g711ulaw

codec preference 3 g711alaw

I feel lost a this point, I really will aprecciate any help.

Thanks

3 REPLIES
Bronze

Re: XConference transcoding problem..

Hi friend, ccm or cme?

If CCM, the hardware conferences resources are registered in your CCM?

Did you assign the conferences resource to a MRG and this to a MRGL and assign it to the IP Phones?

All the best

David.

New Member

Re: XConference transcoding problem..

Thanks for the answer David.

It is CME. I am following this document:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmeconf.html#wp1010877

Thanks

Bronze

Re: XConference transcoding problem..

Hi friend, does the conferencing profile are registered and up? (CME#show dspfarm all), and make sure that your ip phones are configured as dual-lines.

All the best

David.

129
Views
0
Helpful
3
Replies
CreatePlease to create content