I'm currently signed up for both BRKRST-2301, Enterprise IPv6 Deployment and BRKRST-2311, IPv6 Planning, Deployment and Operation Considerations. They appear to be very similar to each other but does anyone know? Am I better off chosing a different session and only going to on of these? If so which one?
My company will be deploying IPv6 dual-stack next year. We currently have it deployed in one of our small remote branch offices that needed it for development but we'd like to roll it out globally including our data center. We're roughly a 1500 employee company with approximately 20 offices worldwide.
Both presentations do have areas that overlap, but they also go into details at different points. I co-present the BRKRST-2311 session and we tend to go into deployment planning, getting yourself organized around the integration process and pitfalls and technicall issues in the process to look for. BRKRST-2301 goes into some of the technical details behind behind IPv6 deployment for an Enterprise organization. We work with the presnter for BRKRST-2301 and we've tried to make the two sessions complimentary and avoid overlap as much as possible, but both sessions will overlap in some areas. Which one you might choose to attend will depend on what you need to get out of the session. I think both sessions are valuable and have good info but I am a bit biased.
Thanks for the feedback! I had to reschedule an exam and it conflicted with the 2311 course but I didn't want to miss it if there was significant value over 2301. However, I really want to get that cert and didn't want to hold until Thursday.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...